YET6141-BZ high brightness LED flashing warning light turns opening the door into a 24-hour silent 'safety patrol'!

YET6141-BZ High-Brightness LED Flash Warning Light: Every time you open the door, it becomes a 24-hour silent "security patrol"! - Written for all those who want to upgrade "safety" to "visible + audible + preventable"!

Why are traditional doorbells and cameras not enough? • The doorbell can only ring "ding-dong", and the camera only records. When an illegal intrusion actually occurs, they cannot deter the intruder immediately; • The back doors of warehouses, fire escape routes, and villa garages, etc., which are "non-primary entrances", are often overlooked and become blind spots in security; • The renovation of old lines is troublesome, and a "plug-and-play" and AC/DC compatible" warning device is needed.

YET has spent 18 months developing the YET6141-BZ, making "seeing" and "hearing" perfect at the same time - one lamp is a miniature security station.

From packaging to accessories, aerospace-grade ABS shell: surface sun patterns + UV coating, does not fade even under 365 days of outdoor exposure; 3 CREE high-brightness LEDs, luminous flux ≥ 100 lm, clearly visible at 100 meters at night; 304 stainless steel bracket, 180° adjustable angle, still stable like a rock even in typhoon days; complete expansion rubber plugs & anti-pull screws, can be drilled through into cement walls, wooden doors, and metal door frames; independent RF antenna interface, can be wirelessly linked with access control hosts and alarm hosts, with a delay of <0.2 seconds.

Wide voltage adaptive: DC 12 V-24 V or AC 110 V-220 V directly connected, no need for additional power converter.

Dual jumper custom mode: ON mode: always on + beeping, suitable for daytime warning at construction sites; FL mode: 1 Hz flash + beeping, the preferred choice for night theft prevention; NC mode: silent flashing, necessary for villa areas that do not disturb neighbors. (The factory default is ON mode, and the switch can be completed within 2 seconds)

Industrial-grade wide temperature design: -10 ℃~60 ℃ operation, -20 ℃~70 ℃ storage, tested for 24 hours without attenuation in a northeastern warehouse with a temperature of -10 ℃ or a tropical port with a temperature of 70 ℃.

3-minute DIY installation tutorial:

Step 1: Power off: ensure the circuit breaker or switch is in the OFF state; Step 2: Remove the lamp board: unscrew the top antenna → use a Phillips screwdriver to remove 4 screws → gently pull out the lamp board; Step 3: Wiring: connect the power line to the "12-220 V" terminal, no polarity; if wireless linkage is needed, connect the RF line of the access control host to the "ANT" terminal; Step 4: Select mode: according to the scene requirements, insert the jumper cap into ON/FL/NC; Step 5: Restore: the wire passes through the bottom waterproof rubber ring → tighten 4 screws → put back the antenna; Step 6: Fix: the bracket aligns with the pre-drilled hole → insert the expansion rubber plug → lock the 2 anti-pull screws; Step 7: Power on: a clear "ding" sound indicates self-check completion, immediately enter the alert state!

Using original CREE light beads, the laboratory continuous flashing aging is ≥ 50,000 hours. Calculated based on 100 flashes per day and 30 seconds each, the theoretical lifespan exceeds 45 years. The entire lamp passes the IP54 rain test, with a back groove design for flow diversion, as long as it is not immersed in water, it can work normally.

The product is continuously in high demand, welcome to place an order!