YET412 and YET412-X 12 channel receiver

Hi everyone, today I will introduce our 12 channel receiver to you.

We have two version for 12 channel receiver, one is YET412 receiver, the other is YET412-X receiver. I will introduce these two receivers to you separately and summarize the differences between them.

Firstly, please allow me to give an introduction of YET412 receiver for you. This receiver is 12v or 24v for optional. 433mhz is supported, 315mhz is also available. It can store 3pcs learning code and fixed code remote control. There are four output means, they are

A.Signal momentary : N0.1 key learning.

B.Signal toggle: N0.2 key learning..

C.Signal latch: N0.4 key learning..

D.6-circuit momentar and 6-circuit toggle: N0.4 key learning.

For details, pls see the wiring diagram showed below,

Next I will introduce methods and steps for learning and the method for eliminating stored Information. There will be two steps for learning, a) Press learning button-buzzer sounds to enter into the learning state. b) Press any button of the remote control-buzzer sounds twice and it indicates that the learning is success. If you lost your remote control and you want to make it invalid , you can Long press the learning button for 8 seconds until the buzzer stop sounding, which indicates that the saved information has been cleared successfully.

Secondly please let me share details of YET402-X receiver with you. You can choose 12v or 24v for this receiver. 433mhz and 315mhz are available .The remote control capacity of it is 80pcs learning code. There are signal momentary、signal toggle 、signal latch and 6-circuit momentary and 6-circuit toggle these four working modes for your choice.

You should follow below method to program,

1. Press “Learning” button, release it until LED light flickers, Receiver in learningstatus this moment.
2. Press any corresponding button on Remote control. If Learning is accomplished,learning indicating light on Receiver will quickly flickers 5 times and then exit Learningstatus. If more than 20s, still no Learning, Receiver will exit Learning status automatically.

If you don’t want to use the remote control which you have programmed ,you can press “Learning” button for 8s until LED goes out, that indicates all stored information has been eliminated.

Okay, above are the details of YET412 and YET412-X I want to share with you. Now you can tell the difference between them, namely the remote control capacity ,one of them is 3pcs and the other is 80pcs. So if you have demand for 12 channel receiver, please take YET412 into consideration. And if you have large remote control capacity requirement for 12 channel receiver ,pls don’t miss our YET412-X receiver. Any interests pls contact us freely.