banner

Installation guidelines for fire intelligent rolling door controllers

128 Published by xia, Crystal Apr 25,2019

Want create site? Find Free WordPress Themes and plugins.

Since the reform and opening up, with the development of China’s economic construction, especially with the deepening of reform and opening up and the improvement of urban modernization, the intelligent roller door machine and controller industry has developed rapidly. In a wide range of fields such as commercial, factory, public facilities, and homes, intelligent rolling doors have gradually replaced traditional rolling doors, and as the core component of intelligent rolling doors, intelligent rolling door controllers have undergone continuous technological upgrading. For example, the controller realizes the transition of the core components from the AC contactor and the air switch to the circuit board, the chip and the relay, thereby realizing the lightness, intelligence and electronicization of the rolling door controller.

Roller shutter WiFi controller can be used with remote control.

The installation of fire shutters is quite important, and the following points need special attention during installation.

First, the fire shutter door power supply

The power supply for the fire shutter door shall be the fire power source; the cross-sectional area of ​​the power supply and control wires, the insulation resistance, the circuit laying and the protection pipe material shall meet the requirements of the specification. The overcurrent protection setting value of the fire shutter door power supply device should meet the design requirements.

Second, the fire shutter controller

A fire shutter door controller is installed on the fire shutter door to control the fire shutter door to perform operations such as up, down, and stop. It is also necessary to set a manual button on both sides (except for the inoperable side of the personnel) to control the lifting, lowering and stopping of the electric fire shutter door, and to lift the function of the fire shutter door after the fire shutter door fire is closed and closed, and the fire shutter door is raised in place. After that, it should be able to automatically restore the original off state.

Third, the fire alarm system of the shutter door

The fire shutter door shall be provided with an automatic alarm control system; the electric fire shutter door shall be provided with an automatic closing control device; the fire shutter door on the evacuation passage shall be controlled by the detector to descend or descend to 1.5m to 1.8m and then delay to the end. Function; for roller blinds that only play a role in fire separation, one step should be lowered to the end. The arm force of the fire shutter door manual quick release device shall not exceed 50N; the fire control room shall have an emergency operation device for forcing the electric fire shutter door to descend and display its state; the opening and closing device of the fire shutter door on the evacuation passage shall be capable of manual operation after the fire is cut off. The mechanical lifting has lowered the closed fire shutter door, and the fire shutter door can be restored to its original closed state by its own weight. Manual fire shutter doors are manually lowered to a traction force of no more than 150N.

After installing the fire shutter door, be sure to check the above equipment and precautions. Connect the fire control center signal line to the fire shutter door controller to fully realize the fire linkage function of the whole fire shutter door.

Did you find apk for android? You can find new Free Android Games and apps.

7.8-7.10 Guangzhou Shading Window-Door Exhibition!

The 9th Guangzhou Shading Window-Door Exhibition will be held at the Guangzhou International Proc...

Do you like ? 95

Read more

Celebrate the 14th anniversary of Yaoertai !

On May 11, 2019, our company Yaoertai was founded 14th anniversary! In the past 14 years, we hav...

Do you like ? 189

Read more

2019, let’s go hiking together!

Saturday, the first week of work in 2019, On a sunny afternoon, Yaoertai, all business colleagues...

Do you like ? 509

Read more

The 28th Beijing Construction Expo will be held soon, and invite you to participate in the grand event!

The 28th China (Beijing) International Building Decoration and Materials Expo will be held on Mar...

Do you like ? 691

Read more

R+T Asia Shanghai Door and Window Sunshade Exhibition, the opening of the 2019 is coming soon

The 15th R + T Asia Shanghai Door and Window Sunshade Exhibition will be held from February 27th ...

Do you like ? 697

Read more

Difference between 433 remote control and 315 remote control and its code method

The frequency used by the radio remote control is 433Mhz or 315Mhz, also referred to as 433 remot...

Do you like ? 1,199

Read more

Infrared alarm principle, function and installation method

The infrared alarm can detect the infrared rays emitted by the human body, and is composed of an ...

Do you like ? 615

Read more

Congratulation YET Global Sources Electronics Exhibition bring to a successful close

Congratulation YET Global Sources Electronics Exhibition bring to a successful close Gate remote ...

Do you like ? 688

Read more
YET2018All Rights ReseverdTechnical Support:Baiila